MacBook Screen Replacement Vienna

€499 for the complete display assembly, including the transfer of camera and sensors, the fitting, the colour check and six months of warranty. For the model years from 2023 it is €599, because those machines carry a brighter panel with many more dimming zones. Nothing is added afterwards. Which of the two applies to you follows from the A-number printed on the underside of the machine.

The Air 15 M2 with A2941, the Air M3 machines A3113 and A3114, every Air M4, and the Pro 14 and Pro 16 of the M3 and M4 years. The dividing line is the model year 2023, not the screen size, which is why a 13-inch Air stays in the lower band while a 15-inch Air from 2023 does not. The Intel Pros all remain at €499.

Because glass, polarising film and panel are bonded across the whole surface, and the display cable, antenna leads and camera wire run through the hinges behind them. Separating the glass ruptures the layer underneath in practically every attempt. Fitting the complete assembly also renews the coating, the hinge resistance and the seal at the same time, which a glass-only job could never deliver even if it worked.

The check is 25 EUR and it comes off the invoice completely as soon as you approve any repair with us. If the panel is healthy and the graphics path, the display cable or the logic board turns out to be the cause, you get a separate price for that first. Where liquid has been in the machine the diagnosis is 49 EUR, because it must be taken apart entirely.

That is the broken backlight ribbon, familiar on the 13 and 15-inch Pros from the Intel years. The thin cable chafes over the hinge edge every time you open the lid until it fails, and the band looks like a stage curtain across the bottom. Apple's own replacement programme for the 2016 and 2017 machines expired five years after first sale. We repair it with a new assembly at €499.

Darken the room and hold a lamp at a shallow angle against the screen. If you can make out windows and the pointer, the machine is computing normally and only the backlight has failed. If the screen stays completely dead, the graphics path or the display cable comes into question instead. Connect an external monitor: a clean picture there places the fault inside the lid with near certainty.

Six months on the display assembly and on the fitting, valid across Austria including machines that arrived by post. If dead pixels, uneven backlighting or a failing cable appear inside that window without a new fall or a fresh spill, we put it right at no cost to you. Fresh impact damage afterwards is not covered, as everywhere. Please ring us rather than opening the lid yourself.

Yes, because they come out of your old lid and go into the new one. The lens, the microphone opening and the wireless antenna leads all live inside the display half, so transferring them is part of the job rather than an extra. After fitting we test a video call and the wireless connection before the machine goes back, since a weak signal after a lid swap almost always means a misrouted antenna lead.

We fit complete assemblies built to the specification of your exact model, matching resolution, brightness and connector. Genuine parts straight from Apple go only to authorised service partners, and we state that openly instead of claiming an origin we do not have. Panels without a datasheet never go into a customer machine. After fitting we check brightness distribution, white point and the automatic ambient light adjustment with you.

The bench work runs two to four hours: the battery is disconnected first, the hinge screws come out, the cables are freed under their covers and the old lid comes off. Then camera and antennas move across. The longest part is the check afterwards, with even illumination corner to corner and two hinges of equal resistance. Most machines go back the next working day when the assembly is in stock.

Yes. Storage is not touched during display work, nothing is reset and nothing reinstalled, so your files, programmes and saved logins are exactly as you left them. On the Apple Silicon machines storage sits fixed on the logic board and we do not go near it. A current backup is still sensible before any hardware work, simply because storage can fail without warning.

Often yes, but quickly rather than eventually. Switch the machine off, leave the charger out and bring it in, because stains behind the panel spread and the board underneath corrodes day by day. The lid itself is renewed as an assembly, and the board is cleaned separately from €99. The liquid diagnosis is 49 EUR because the machine is stripped completely. Rice and hairdryers only buy the corrosion more time.

Yes, from any district. Our driver takes the machine from your home or your office and brings it back afterwards, with both journeys inside the zone price of €14.90, €17.90 or €18.90. Put a cracked machine in a bag or a box so loose splinters stay contained, and please do not press the lid shut on the way. Most customers have it back the next working day.

Yes, from all of Austria, with insured return shipping already in the price. Shut it down, lay a sheet of paper over the panel so splinters do not press into the keyboard, wrap it well and use a firm box with generous padding. Add a note with your name, number and the A-number from the underside. We ring you with the exact figure before any work begins.

Yes, at a slot you book in advance, in the 22nd district. There is no walk-in counter with opening hours, because working by appointment is what guarantees somebody is there and your machine goes onto the bench immediately. The exact address comes with your confirmation. Doing it in person is optional though: the courier in Vienna and the post from anywhere reach the same workshop and the same prices.